Image 1

Ride Pants Shockwave Moto Pant Yellow PWC Jetski Ride & Race Gear

Your Price:
$40.00 (You save $94.99)
JTG 11410-YL
2.00 LBS
Usually Ships in 24 Hours
Calculated at checkout
Related Products
Product Videos
Also Viewed
By Category
Other Details
  • Product Description

    Ride Pants Shockwave Moto Pants - Yellow 

    This is a closeout item. No additional sizes will be made available.

    • Tough Sato 420 D. and ballistic nylon with 2 coats of PU for wind and water resistance.
    • Inner mesh liner to keep a layer of air between your skin and the outer layer.
    • Neoprene side panels for warmth and flexibility.
    • Vents to allow air flow, reducing the ballooning effect at high speeds.



    30 (76 cm)

    32 (81 cm)

    34 (86 cm)

    36 (91cm)

    38 (97cm)

    40 (102cm)


    The Jettribe SHOCKWAVE Moto riding pants are designed and specially built for the true PWC rider, not just moto-x pants worn in the water. With the PWC rider in mind, our Jettribe R&D team built these riding pants to provide maximum flexibility, comfort, and protection. Jettribe understands that riders in the past wore typical wetsuits for protection while riding, but riding with wetsuits can be cumbersome, restrictive and hard to get in and out of. Most riders still need the protection against the bumps and bruises while riding. With this in mind, Jettribe built the Moto Pants with many features that set our product apart.

    The knee and shin areas have EVA compression foam molded pads for that added protection. But our high density EVA foam will not absorb water and stays light. The main material is a tough Sato 420 D. nylon with 2 coats of PU. This material is light and very strong, providing wind and water resistance. Wind and water are really what make you cold. In the inseam panel area, we built an air mesh panel to allow water to pass through and allow you to stay light while keeping in your body heat. The rear panel is constructed out of neoprene to allow maximum flexibility. This panel is also embedded with our Jet Grip - a silicone texture to maximize grip from your "butt" to your runabout's seat. The dual side pockets have a built in drain hole on the outside and the inside is mesh. This allows the water to drain straight through. Once again, we built these pants to be light while wet. Our single pull tight system allows for instant belt release or tightening. Just one pull to tighten or one quick press on the 50 MM buckle to release the waist belt.

    The Jettribe Moto Pants are literally used & abused by many of our team riders at the IJSBA World Finals. Yes, these pants are not only tested, but race tested. The Jettribe Moto Pants are not built to replace the wetsuit but they are a great alternative. They provide the PWC rider with comfort and protection against the elements white looking very cool on or out of the water. See you at the next race!!!


    Ride Pants Shockwave Moto Pant Yellow PWC Jetski Ride & Race Gear Jet Ski  

  • Product Reviews


    Write A Review

    1. Ready to Race

      nice on 24th Feb 2019

  • Product Videos

    • James Bushell IJSBA World Finals 2016
      Jettribe Factory Rider James Bushell interview during the 2016...
    • Jettribe Factory Rider Phil Pope World Finals Interview 2016
    • Jettribe Factory Rider Brock Austin Talks about his Devas Bling Helmet
    • Jettribe Factory Rider Brad Rickaby at IJSBA World Finals 2016
      Interview with Brad Rickaby at the 2016 IJSBA World Finals in ...

    James Bushell IJSBA World Finals 2016

    Jettribe Factory Rider James Bushell interview during the 2016 IJSBA World Finals in Lake Havasu.
  • Find Similar Products by Category